SPR Insertion Tool

Steck’s new SPR Insertion Tool is a high-grade, hardened steel frame, that uses a 1/2” 20 grade 8 hex bolt, with a magnetic end and center recess to hold the replacement SPR, while inserting it with your 3/4” or 19mm socket using your 1/2” impact wrench.

1) Technician locates a spot on the flange area, next to the SPR you just removed (after you have replaced the door skin or quarter panel.

2) Insert the new SPR on the magnetic end of the bolt, hand tighten to the flange area keeping the body of the tool against the door flange.

4) Replace the required SPR’s and re-install trim panel according to manufacturer procedures.